Stayve Seanergy Peel Ampoule Kit Sea + Energy

Stayve Seanergy Peel

It brings new energy to the skin from the deep clean sea.

No side effects will be caused as it is made of natural ingredients.
It works as micro-particles are embedded in the skin and remove dead skin cells and waste on the skin.
It stimulates the skin to lift, elastic, and make the skin texture soft.

Net contents 10vials/box

Seanergy Peel Powder 1.3g X 5vials
Seanergy Peel Solution 8ml X 5vials

Stayve Seanergy Peel steps 

1) Preparation
Cleanse your face by using Stayve Mild Cleansing Milk. Refine your skin by applying or spraying Stayve Hydrating Rose Toner. 
After refining your skin, apply anesthetic cream and after 30minutes, wipe away clearly before you begin the treatment. 
Mix Seanergy Peel Powder and Seanergy Peel Solution. 

2) Treatment
The treatment goes by right cheek -> left cheek -> forehead, and nose accordingly. 
Apply the mixed solution and lightly press, and this action calls as "Rubbing". At this moment, around 2 ~ 3 minutes take per area, reapply the solution during the "Rubbing" and proceed precisely. 
After "Rubbing" is done, repeat pressing the whole area of the treatment. 
*Do not attempt "Rubbing" strongly on the sensitive skin such as eyes and mouth area, but lightly press it. 

3) Removing the residue
Remove the residue on the outer skin by using a wet sponge or gauze. Be careful as the effect of micro-particles might reduce when it's wiped strongly. 
*It is natural to feel as if thorns are pricking your face.

4) Finalizing
Put on a mask sheet for soothing and moisturizing on the face that has been stimulated. It is better when used after storage at cold temperature. 
Apply enough amount of Stayve Booster Ampoule(depending on your skin type) and Stayve Repair Cream. 

After care Stayve Seanergy Peel

- Apply sunscreen precisely after the treatment. Freckles or pigmentation might occur when exposed to the sunlight without applying sunscreen. 
- Lightly cleanse your face with a wet sponge or warm water for 1 ~ 2 days after using Stayve Seanergy Peel Ampoule. 
- Use hypoallergenic cleanser for 3~5 days after using Stayve Seanergy Peel Ampoule. Prohibit using wet tissue, soap, or any other exfoliating products and products with pellet/grain. 
- Apply plenty amount of ampoule or cream that is helpful for moisturization often, for every 7 ~ 8 hours, until all the dead skin cells drop. 
- Do not touch the face with unhygienic hands.
- Do not peel off the dead skin cell forcefully and care for the moisturization properly until all the dead skin cells drop naturally. 

Cautions

- Sunscreen must be applied when you go out after getting the treatment. (Freckles or pigmentation might occur when exposed to the sunlight without applying sunscreen.)
- Pay attention to the hygiene of hands before and after the treatment. 
- It is natural to tingle when rubbing or after rubbing(around 1 ~ 2 days). 
- The skin might be itchy when granulate after the treatment. 
- Lightly cleanse your face a day after the treatment. Do not use cleansers that contain exfoliating ingredients such as scrub, AHA, BHA, and etc.
- Avoid sports, spa, sauna or food that makes you sweat. (Especially alcohols are prohibited)
- Avoid functional cosmetics such as whitening/anti-wrinkles that contain retinol as an ingredient. 
- Not recommended to people with the severely thin skin layers.

Expiration

• expiration stated on the box

• once opened use within 2 weeks and store in the fridge
   

Country of origin: Stayve product made in Korea

#bbglow #stayve #seanergy #peel #powder #solution